GT:Config Scan Detect Window

From coolearthwiki
Jump to: navigation, search

Some customers need to know whether the tracking # information was manually entered, or if it was scanned into the system. Whistle will track this information for you.

Image:Scan1.gif


In order to determine whether tracking # has been manually entered or scanned, Whistle uses the amount of time from when the entry was start to when it was completed. Anything over a certain amount of time is considered to have been manually entered, as scanning is done much quicker. Most of the time, the default values used will give an accurate determination as to the input method. However, due to differences in equipment, setup, etc., sometimes the default settings need to be adjusted. This can be done in one of two ways.

Configuring Scan Detection

Scan a tracking label in the Track field. Whistle will set the numbers.

Image:Scan2.gif

or

Enter the values manually.

Image:Scan4.gif

Select "<OK>" to save the changed values.

There are no window settings for this window.