QC Yield

From coolearthwiki
Revision as of 21:19, 25 June 2015 by 10.0.0.129 (Talk) (Created page with "=QC Yield - Introduction= This section describes how to use the QC Yield application for capturing and recording tree and wagon weights. These yields are then used for autom...")

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

QC Yield - Introduction

This section describes how to use the QC Yield application for capturing and recording tree and wagon weights. These yields are then used for automatic release of a tree or wagon based on a target yield for a particular product.

Accessing the QC Yield Application

The QC Yield application should be active on your reporting station touchscreen. You must log on to the application using the supplied credentials for the unit you are operating.

Creating a Yield Record

Yield1.PNG


In the Track field, enter the pallet number whose weight is to be tested. This field is required, indicated by the red dot next to the field label, showing a required field that has not yet been filled in.

If the percentage of shrinkage of the pallet has not yet reached the required range, you will see the Out of Spec notice.


YieldOutOfSpec.PNG


If the percentage of shrinkage of the pallet has reached the required range, you will see the In Spec notice.


YieldInSpec.PNG


The weight of the sample is either entered, or is sent from an attached scale.

YieldInSpecWeight.PNG


The resulting record is saved when the Add record key is pressed, and shown in the bottom grid. Each weight taken of the same pallet will result in a new record being written, keeping track of the shrinkage of the inventory on that pallet over time.


YieldSample.PNG



Return to MES/WIP